STEP #2 The milling process The discs were fused to form a single cylinder. See next page.		Click on image to advance to the next step in the milling process.

STEP #3 The cylinder is then turned on a mill to form a cone. See next page

Click on image to advance to the next step in the milling process.

STEP #4 The cone is sliced to extract a wedge out of its center. See next page		Click on image to advance to the next step in the milling process.

Hiçbir yazı/ resim  kaynak gösterilmeden kullanılamaz!!  Telif hakları uyarınca bu bir suçtur..! Tüm hakları Çetin BAL' a aittir.

The Time Machine Project © 2005 Cetin BAL - GSM:05366063183 -Turkiye/Denizli 

Time Travel Technology /UFO Technology / Roket bilimi / CetinBAL