STEP #2 The milling process The discs were fused to form a single cylinder. See next page.		Click on image to advance to the next step in the milling process.

STEP #3 The cylinder is then turned on a mill to form a cone. See next page

Click on image to advance to the next step in the milling process.

STEP #4 The cone is sliced to extract a wedge out of its center. See next page		Click on image to advance to the next step in the milling process.

  [Home | Aliens| Gravity Waves | Archive | UFO Project  | Downloading |

  Hiçbir yazı/ resim  kaynak gösterilmeden kullanılamaz!!  Telif hakları uyarınca bu bir suçtur..! Tüm hakları Çetin BAL' a aittir.

  © 1998 Cetin BAL - GSM:05366063183 -Turkiye / Denizli 

    Ana Sayfa ·  Index·  UFO Galeri /   E-Mail /  Time Travel Technology / 

    UFO Technology / Roket bilimi /